ECET310 Week 2

Question # 00044830 Posted By: spqr Updated on: 01/29/2015 08:28 AM Due on: 02/21/2015
Subject Engineering Topic General Engineering Tutorials:
Question
Dot Image

ECET310 Week 2 TEST NAME:______________________________. GRADE= /32

Note:

There are 2 pages.

3 points for each blank.

Complete the test and put into drop box (week 2 TEST) for grade. Keep answers in 2 digits after decimal point. Must submit in time (time stamp verified). No grade for no or wrong units.

1.

Ap1=10dB Ap2=20dB Ap3=30dB

NF1=3dB NF2=4dB NF3=5dB










A three stage amplifier is shown. The operating bandwidth is 300 KHz at a temperature of 20° C. The output load is 1.5K?.

a. Total power gain as a number = ____________

b. total NF as a number = ____________

c. Total thermal noise power at input = __________

d. Total noise power at output = ____________

e. Output noise voltage = ____________

2. Determine percent of total harmonic distortion if fundamental has RMS voltage of 5 V, 2nd harmonic is 1V, and 4th harmonic is 0.7V and 5th harmonic is 0.5V.

Answer= ______________

3.

image011

Note: R=1?, C=79.58uF, L=477.46uH

For the circuity above, the frequency of source signal is tunable, and we intend to tune to resonant frequency Fr. (The followings are sequential events)

a) Fr= _____________

b) When the circuit is tuned to Fr, the current through R measured using DMM = _____________; and Power delivered to that 1? resistor = ___________.

(note: 1V in the circuit is the peak value)

c) The system requires that the engineer to increase the resonant frequency to be 10 times of Fr found in (a) and can only change capacitor and keep R and L unchanged.

The new capacitor value = _____________.

d) The engineer replaces the R in the circuit above with a 100? resistor, then resonant frequency of this new circuit, Fr=_____________.

e) After operating at Fr for a while, suddenly capacitor in the circuit is burnt to become OPEN, then we shall see that the current through R (100? ) measured using DMM become ___________ (increased, decreased, or unchanged).

Dot Image
Tutorials for this Question
  1. Tutorial # 00043587 Posted By: spqr Posted on: 01/29/2015 08:29 AM
    Puchased By: 2
    Tutorial Preview
    The solution of ECET310 Week 2...
    Attachments
    ECET_310_Week2_test.zip (29.87 KB)

Great! We have found the solution of this question!

Whatsapp Lisa