Final Control Lab

Question # 00450464 Posted By: schoolbench Updated on: 12/27/2016 08:25 PM Due on: 12/30/2016
Subject Engineering Topic General Electrical Engineering Tutorials:
Question
Dot Image
Final Control Lab
  1. The SCR in Figure 1 below requires a 3 V trigger. Using Multsim, design a system by which the gears are shifted when a CdS photocell resistance drops below 4k.

    Figure 1

  2. Using Multisim, design a system by which a control signal of 4 to 20 mA is converted into a force of 200 to 1000N. Use a pneumatic actuator and specify the required diaphragm area if the pressure output is to be in the range of 20 to 100kPa. An I/P converter is available that converts 0 to 5 V into 20 to 100 kPa. A block diagraph of the system is shown below. (Hint: Use a differential amplifier. You are only designing the circuit to interface into the I/P below)
Dot Image
Tutorials for this Question
  1. Tutorial # 00446263 Posted By: schoolbench Posted on: 12/27/2016 08:26 PM
    Puchased By: 4
    Tutorial Preview
    The solution of Final Control Lab (Tutorial Guide)...
    Attachments
    answer.zip (511.04 KB)

Great! We have found the solution of this question!

Whatsapp Lisa